elem Garden Technic ASB3000-16 Traduction Des Instructions D'origine page 16

your product, only the following cable dimensions should
be used:
– 1.0mm2: max. length 40 m
– 1.5 mm2: max. length 60 m
– 2.5 mm2: max. length 100 m
Note: If an extension cable is used it must be earthed
and connected through the plug to the earth cable of
your supply network in accordance with prescribed
safety regulations.
If in doubt contact a qualified electrician or the nearest
Service Center.
WARNING! Inadequate extension cables can be
dangerous. Extension cable, plug and socket
must be of watertight construction and intended
for outdoor use.
It is recommended for increased electrical safety to
use a Residual Current Device (RCD) with a tripping
current of not more than 30 mA. Always check your
RCD every time you use it.
MAINTENANCE
Keep all nuts, bolts and screws tight to ensure that the
leaf blower/garden vacuum is always in a safe working
condition.
The leaf blower/garden vacuum should be stored
in a dry, high or locked up place out of the reach of
children.
Replace worn or damaged parts for safety.
Check the collection bag frequently for wear or
deterioration.
Do not attempt to repair the machine unless you
are qualified to do so.
DESCRIPTION
Your blower vac has been designed for leaf
clearing. This tool is intended for consumer and outdoor
use only.
1. Cable strain relief
2. catcher bag
3. power cable
4. front handle
5. On / off switch
6. Suction and blow-mode selector
7. Suction and blowing mode lever
Attaching the catcher bag (Fig. 2,Fig. 3)
ATTENTION! Pull out the plug before the catch bag
attach or remove.
Before attaching the collection bag, make sure that the
suction and blowing mode lever lets you use any
resistance and that access is not obstructed by dirt (for
example, leaves residues, etc.) of the previous use.
To mount the catcher bag, push the handle / connector
(Fig. 2, Pos. 2.1) at the appropriate location of the casing
(Fig. 2, Pos. 2.3). Make sure that the key (Fig. 2, Pos. 2.2)
is locked in the correct position.
To remove the catch bag, press the button (Fig. 3, Pos.
3.1), and then pull the catch bag from the housing.
Seite 16 von 36