Roof Venting Installation Only - Whirlpool WMHA9019HZ Instructions D'utilisation

13. Secure damper plate with 2 screws removed in Step 1.
A
B
A. Damper plate
B. Screws

Roof Venting Installation Only

1. Repeat Step 1 from "Wall Venting Installation Only."
2. Repeat Step 2 from "Wall Venting Installation Only."
3. Repeat Step 3 from "Wall Venting Installation Only."
4. Repeat Step 4 from "Wall Venting Installation Only."
5. Repeat Step 5 from "Wall Venting Installation Only."
6. Using diagonal wire cutting pliers, gently snip out the
rectangular vent covers on the damper plate at the
perforations.
B
A. Rectangular vent covers
B. Diagonal wire cutting pliers
7. Lower blower motor back into microwave oven. Exhaust
ports face the top of microwave oven.
A. Exhaust port
IMPORTANT: If blower motor is not positioned with flat
side facing the back of the microwave oven (as shown),
performance will be poor.
A
A
8. Reconnect the blower motor wire into the connector.
9. Reattach the 2 blower screws into the recessed holes in the
back of the microwave.
10. Check to make sure the 2 screws are secured properly in the
blower motor screw holes, so that the motor cannot move.
11. Return the damper plate to its original horizontal position.
A
A. Damper plate
12. Secure damper plate with 2 screws removed in Step 1.
A
B
A. Damper plate
B. Screws
7