Connec Ng Equipment To The Tw - Gallagher TW-3 Guide De Démarrage

Gallagher TW- Weigh Scale Quick Start Guide
CONNECTING EQUIPMENT TO THE TW-3
Connecting to an EID Reader
The EID Reader can be connected to the TW- by either a serial cable or via
Bluetooth®.
1. Turn On the EID Reader.
2. Turn On the TW- .
3. On the TW- , tap
4. Select how the Reader is being connected, either via Bluetooth or using a
serial cable.
Note: A mini serial adapter is included with the TW- if a female serial
connec on is required.
Important: The TW- can also be connected to via Bluetooth as a "Slave",
by ini a ng the connec on from the reader. A passcode of "0000" may be
required to complete this connec on.
Refer to Bluetooth – Connect EID Reader in the TW-3 On-screen Help or your EID
Reader User Manual for further informa on on pairing the reader.
Connecting to a Drafter/Sorter
To connect the TW- to a dra er, use the data cables suppled with your dra er.
Refer to your Dra er User Manual for more informa on.
1. Turn On the TW- .
2. On the TW- , tap
3. Specify the type of dra er that is being connected, to complete the setup.
If your dra er is not listed, tap
wizard set up your dra er.
Se ngs > Equipment Connec ons > EID Reader
Se ngs > Equipment Connec ons > Dra er
Create Custom
and follow the confi gura on
.
.
7