Preparing For Use; Using The Appliance - Philips Suncare HB811 Mode D'emploi

If you want to keep your tan, do not stop tanning after the course, but continue taking one or two tanning sessions a week.
Whether you choose to stop tanning for a while or whether you continue tanning on a lower frequency, always keep in mind that you
must not exceed the maximum number of tanning hours.
For this appliance the maximum is 21 tanning hours (=1260 minutes) a year.
Example
Suppose you take a 10-day tanning course, with an 8-minute session on the first day and a 20-minute session on the nine following days.
The entire course will then last (1 x 8 minutes) + (9 x 20 minutes) = 188 minutes.
This means you can take 6 of these courses in a year, as 6 x 188 minutes = 1128 minutes
Of course, the maximum number of tanning hours applies to each separate part or side of the body that is tanned (e.g. the back and front of
the body).
As is shown in the table, the first session of a tanning course should always last 8 minutes, irrespective of the sensitivity of the skin.
B If you think that the sessions are too long for you (e.g. because your skin feels taut and tender after the session), we advise you to reduce the length
of the sessions by e.g. 5 minutes.
For a beautiful all-over tan, turn your body slightly during the session so that the sides of your body are better exposed to the tanning light.
B
Duration of the UV session for
each separately treated part of
the body
1st session
rest of at least 48 hours
2nd session
3rd session
4th session
5th session
6th session
7th session
8th session
9th session
10th session
*) or longer, depending on your skin sensitivity.
If your skin feels slightly taut after tanning, you can apply a moisturising cream.

Preparing for use

The appliance can be easily moved in transport position (fig. 1).
The appliance is easier to lift if you do so together with another person.
If you have to lift the appliance by yourself, use the handle (fig. 2).
1 To open the appliance, move the slides in the direction of the arrow (fig. 3).
2 Pull the stand and the lamp unit up (fig. 4).
3 Put the tanning appliance in the position indicated (fig. 5).
4 Pull the lamp unit up to horizontal position. Use the handle to do this (fig. 6).
You will hear clicks when you move the lamp unit past certain fixed positions.
Instead of using the above step-by-step method, you can also pull the lamp unit up by its handle in one single movement (fig. 7).
5 Turn the lamp unit a quarter turn (fig. 8).
6 Place the tanning appliance beside a bed as indicate in the figure (fig. 9).
The distance between the UV filter and the surface on which you are lying down (e.g. the bed), must be 85 cm.
7 Loosen the height adjustment lock by sliding the collar down the stand. Pull the lamp unit up at the same time to a height of 85 cm
above the bed (fig. 10).
Let go of the collar to lock the lamp unit into position.
You can check the distance between the lamp unit and the bed by pulling out the measuring tape.
The measuring tape will automatically rewind if you move the red tab sideways.
The appliance is now ready for use.

Using the appliance

1 Fully unwind the mains cord.
2 Put the plug in the wall socket.
B Consult the table in these instructions for use and your own notes.
Put on the protective goggles provided.
B
For persons with very sensitive
skin
8 minutes
10 minutes
10 minutes
10 minutes
10 minutes
10 minutes
10 minutes
10 minutes
10 minutes
10 minutes
For persons with normal
sensitive skin
8 minutes
20 - 25 minutes
20 - 25 minutes
20 - 25 minutes
20 - 25 minutes
20 - 25 minutes
20 - 25 minutes
20 - 25 minutes
20 - 25 minutes
20 - 25 minutes
ENGLISH
For persons with less sensitive
skin
8 minutes
30 minutes*
30 minutes*
30 minutes*
30 minutes*
30 minutes*
30 minutes*
30 minutes*
30 minutes*
30 minutes*
5