Display Settings - Kenwood KMM-BT408DAB Mode D'emploi

Display Settings

Zone identification for brightness setting
Set the dimmer
Press and hold DISP to turn on or off the dimmer.
• Once you press and hold this button, [DIMMER] setting will be overwritten.
Change the display settings
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3 Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4 Press and hold to exit.
To return to the previous setting item, press
[DISPLAY]
[DIMMER]
[BRIGHTNESS]
[TEXT SCROLL]
[CLOCK]
[CLOCK DISPLAY]
[DEMO MODE]
.
Dims the illumination.
[ON]: Dimmer is turned on.
[OFF]: Dimmer is turned off.
[DIMMER TIME]: Set the time to turn on dimmer and to turn off dimmer.
1 Turn the volume knob to adjust the [ON] time, then press the knob.
2 Turn the volume knob to adjust the [OFF] time, then press the knob.
Default: [ON]: [18:00] ; [OFF]: [6:00]
Sets the brightness for day and night separately.
1 [DAY]/[NIGHT]: Select day or night.
2 Select a zone. (See the illustration on left column.)
3 [LVL00] to [LVL31]: Set the brightness level.
[ONCE]: Scrolls the display information once. ; [AUTO]: Repeats scrolling
at 5-second intervals. ; [OFF]: Cancels.
• Not applicable to Dynamic Label display information (page 31) while
in DIGITAL AUDIO source.
[ON]: The clock time is shown on the display even when the unit is turned
off. ; [OFF]: Cancels.
[ON]: Activates the display demonstration automatically if no operation is
done for about 15 seconds. ; [OFF]: Deactivates.
Default: [XX]
23
ENGLISH