Maintenance; Care And Cleaning; Metal Rack; Cleaning The Grease Filters - LG LMV1751 Serie Manuel De L'utilisateur

Masquer les pouces Voir aussi pour LMV1751 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CARE AND CLEANING

For best performance and safety, keep the oven clean
inside and outside. Take special care to keep the inner
door panel and the oven front frame free of food or
grease build-up.
Never use rough powder or pads. Wipe the
microwave oven inside and out, including the hood
bottom cover, with a soft cloth and a warm(not hot)
mild detergent solution. Then rinse and wipe dry. Use a
chrome cleaner and polish on chrome, metal and
aluminum surfaces. Wipe spatters immediately with a
wet paper towel, especially after cooking chicken or
bacon. Clean your oven weekly or more often, if
needed.

METAL RACK

Wash the metal rack with a mild soap and a soft or
nylon scrub brush.Dry completely.
Do not use abrasive scrubbers or cleaners to clean
rack.

CLEANING THE GREASE FILTERS

The grease filters should be removed and cleaned
often, at least once a month.
1. To remove grease filters, slide each
filter to the side, then pull filters downward.
The filter will drop out.
2. Soak grease filters in hot water and a mild
detergent. Rinse well and shake to dry. Do not use
ammonia or place in a dishwasher. The
aluminum will darken.

MAINTENANCE

3. To reinstall the filters, slide it into the side slot, then
push up and forward to lock.
NOTE: Do not operate the hood without the filters in
place.

CHARCOAL FILTER REPLACEMENT

If your oven is vented inside, the charcoal filter should
be replaced every 6 to 12 months, and more often if
necessary. The charcoal filter cannot be cleaned.
To order a new charcoal filter, contact the Service
Center.
1. Unplug
power supply and wear gloves.
2. Remove the two vent grille mounting screws.
(2
3. Tip the grille forward, then lift it out
4. Open the door.
5. Remove old filter.
6. Slide a new charcoal filter into place and close the door.
The filter should rest at the angle shown.
7. Slide the bottom of the vent cover into place. Push
the top until it snaps into place. Replace the mounting
screws. Turn the power back on at the main power
supply and set the clock.
- 24 -
the oven or turn off power at the main
screws)

Publicité

Chapitres

Table des Matières
loading

Table des Matières