Inglesina DARWIN BASE Manuel D'instructions page 17

HINTS FOR CLEANING AND MAINTAINING THE PRODUCT
• The child car seats could leave traces on the vehicle seats, due to the measures taken
to install it firmly in compliance with safety standards. This product was designed to
minimize this effect as much as possible. The manufacturer cannot be considered
liable for eventual traces deriving from normal use of the child car seat.
• Never force any mechanisms or moving parts; in case of doubt, check the instruction
first.
• Store the product in a dry place.
• Protect the product against weather agents, water, rain or snow; moreover,
continuous and prolonged exposure to sunlight can cause changes in the colour of
many materials.
• Clean the plastic and metal parts with a damp cloth or with a mild detergent; do not
use solvents, ammonia or benzine.
• Carefully dry metal parts after any contact with water to prevent the formation of
rust.
INSTRUCTIONS
LIST OF COMPONENTS
DARWIN i-SIZE BASE
fig. 1
A Support foot
B Red/green support foot position indicators
C Support foot height adjustment lever
D Isofix connectors
E Isofix connector position release lever
F Pushbutton for Isofix connector's disengagement
G Lever to release the Isofix connectors
H Indicators of Isofix connector's engagement
I Red/green indicators for hooking the seat on the base
J Child seat engagement housings
K Child seat release lever
L Isofix anchoring points on the car seat
M Instruction manual compartment
IMPORTANT
• Verify where the Isofix anchoring points are positioned on the seat of the car and
check that they are free from any materials that could prevent their correct use.
• Verify that on the seat of the car there are not any items that may hinder the correct
leaning of the car base to the seat.
• Verify that the floor of the car is free from any materials that may hinder the correct
grip of the support foot.
• Verify that the backrest is in vertical position and the seat where the car base has to
be installed is NOT EQUIPPED WITH FRONT AIRBAG.
POSITIONING AND INSTALLING THE DARWIN i-SIZE BASE
fig. 2 Extract the support foot (A) from beneath the car base.
17