Saey 477.0220.000 Mode D'emploi page 26

Mounting the outlet tube (optional part) for an upright fumes outlet (ref.
479.0094.XXX)
First you should dismantle the round part you find in the top plate. To do
this you should untighten the hexagon nut (SW10) you find at the back
side of the stove. This nut keeps the cast iron bar in place.
Then you can fasten the outlet tube with the two hexagon nuts (M6 x 20)
as well as the 4 washers and the 2 hexagon nuts M6. Finally you should
go with your hand through the opening in the top plate in order to fasten
the round part again with the cast iron bar on the back side of the stove.
Take note of the following precautionary measures before the smoke
duct is installed :
- The diameter of the smoke duct may not be reduced, the smoke
duct may not be made smaller and it may not be positioned
horizontally, but should rise towards the chimney at a slight angle.
- The stovepipe must fit into the chimney opening to make the
discharge of fumes possible. Make provision for a double lining in
this regard.
- Chimney connections of different stoves may not be so positioned
opposite one other, i.e. at the same height. This may obstruct the
discharge of echaust fumes. The minimum distance between two
outlets for fumes should be at least 30 cm.
- Do not connect too many stoves to one chimney – too many
connections hamper the upward draught.
sweeper for advice.
- The chimney may not conduct any false air.
chimney control valves as well as the cleaning openings in the
cellar are closed.
- The smoke duct must be securely attached to the connector.
3.4 Saey 200 + cucina
The discharge of fumes takes place at the
back of the stove.
26
Ask your chimney
Ensure that the