Iberspa Ready2Enjoy Guide D'utilisation page 9

1. Unfold the spa liner to lay flat.
2. Connect the inflation hose to the
blower exhaust fitting on the top
of the power pack.
The key lock pin must be inserted into the adapter of the
inflation hose fitting when inflating the spa. Failure to insert
the key lock pin may result in injury.
3. Insert the key lock pin into the inflation hose fitting on the top of the
power pack.
4. Plug the power pack into the electric outlet. Press the Turbo Wave On/Off
button to start the inflation.
NOTE: The power pack will make a rattling noise while the pump is
running with no water. This is normal. Do not run the power pack
without water for more than 15 minutes.
5. Inflate the three spa side tubes and the spa interior floor.
NOTE: Do not over inflate the lower tube. Over inflation may cause lack
of air flow and water action.
ASSEMBLY
ENGLISH