Cleaning The Filter - Iberspa Ready2Enjoy Guide D'utilisation

Adding Chemicals
1. Always activate the turbo wave blower when adding chemicals to the spa.
Add only one chemical at a time.
Failure to properly dissolve or dilute chemicals prior to
adding them to the spa may damage the spa vinyl surfaces
and will void your warranty.
2. When adding chemicals, dip a few gallons of water from the spa into a five
gallon bucket. Dissolve or dilute the chemicals in the bucket. Stir the
bucket until the chemicals are fully dissolved or diluted. With the turbo
wave blower turned on, slowly pour the bucket into the spa in the stream
of the water jets.
3. Do not use gas chlorination, chlorine tablets, ionizers, scents, salts, or
soaps without consulting your authorized dealer
Cleanliness
1. Drain and refill the spa every three months, or when the water becomes
cloudy and is not cleared by proper water chemistry.
2. Remove and clean your filter at least once a week. A dirty filter will prevent
water flow and may prevent the spa from heating.
Vinyl Repairs
If the vinyl is torn or punctured, repair it with the patch kit provided with your
spa. A secure, unnoticeable repair can usually be made. Additional vinyl pieces
may be obtained through your authorized dealer.

Cleaning the Filter

1. Unplug the power pack from the electrical
outlet.
2. Using the three caps provided, cap the
suction and discharge fittings on the inside
of the spa.
3. Open the air bleed fitting on the top of the
filter tank.
ENGLISH