Site Preparation; Indoor Installation; Outdoor Installation - Iberspa Ready2Enjoy Guide D'utilisation

SITE PREPARATION

1. Structure: Your spa should always be installed on a structurally sound, relatively
smooth, and level surface.
2. Elect rical: Your spa should be connected to a grounded outlet within eight feet of
the spa. For 120 V units, there should be easy access to the plug for periodic testing
of the cord mounted GFCI.
3. Bonding: A copper wire connector is located inside the spa power pack to permit
connection of a minimum No. 8 A.W.G. (No. 6 for Canada) solid copper bonding
conductor between any metal equipment, water pipe, or metal enclosures within 5
feet of the spa as required to comply with the National Electric Code, or local
requirements.

INDOOR INSTALLATION

Give special consideration to the following issues when installing your spa indoors.
1. Make sure the floor can support the total spa filled weight of 1480 pounds.
2. Install your spa on water resistant, non-slip floor. The floor should have a drain to
remove water splashed from the spa. Do not install the spa on carpet or other
material that will be damaged by moisture.
3. Take into consideration the room humidity which will exist due to high
temperatures. Providing natural or forced ventilation in the room will help maintain
comfort and minimize moisture damage to the surrounding environment.
4. Avoid installing the spa indoors on a second story above finished living space due to
the possibility of water and humidity damage.
5.Allow enough clearance around the spa for full access to the spa equipment for
service.

OUTDOOR INSTALLATION

Your spa may be installed on any level, smooth surface that is strong enough to support
the filled unit. Observe the following considerations when deciding where to place your
spa:
1. Make sure there are no sharp objects under the spa.
2. Do not install the spa on grass or dirt, as this will greatly increase the amount of
debris entering the spa. Stepping stones or a solid wood 8 ft x 8 ft square platform,
5 to 9 inches in height, will provide a sufficient area for installation.
3. Verify that there is adequate room to place the spa and permit safe access.
4. Check local code requirements for restrictions (fencing, enclosures, child proof
gates, etc.)
INSTALLATION
ENGLISH