Control Panel Operation - Friedrich WallMaster WCT08 Manuel D'installation Et D'utilisation

Control Panel Operation

All of the control panel function buttons and mode icons can be viewed in Figure 3.
Power On – Press the button to turn on the air conditioner. The power button illuminates to indicate that the power is on. The backlight on the power switch
will automatically turn off after 20 seconds of inactivity. The remote control can also be used to turn power ON / OFF (See Remote Control).
Display – The display is a high efficiency LCD with a built-in backlight. After 20 seconds of inactivity, the display switches off. Touching any button
automatically changes the display to full brightness.
There are three control push buttons on each side of the display.
Figure 3
SYSTEM FAN MODE
Cycles between Sets fan to either:
AUTO, HEAT, - Cycle automatically
COOL, or FAN - Run continuously
ONLY
(if equipped)
Figure 4
COOL HEAT FAN ONLY
MODE
Cycles between
COOL, HEAT, FAN
ONLY or -AUTO-
(if equipped)
FAN
Sets fan to either:
- Automatically cycle
- Continuously run
FAN SPEED
Sets fan speed:
LOW, MED, HIGH,
OR MAX
(Actual settings are
model dependant)
FAN SPEED TEMPERATURE
Sets fan speed: Increment UP
LOW, MED,
HIGH or AUTO
TEMPERATURE
(if equipped)
Increment DOWN
-AUTO- ON / OFF
Automatically switches
Turns unit on/off
between cool & heat
2 DIGIT DISPLAY
Shows Setting for:
- Set Point (Temperature)
- Clock (AM/PM)
TIMER IR WINDOW
Turns ON or OFF Do not block
DISCONNECTED CONTROL
FROM POWER BOARD LOCKED
ON / OFF
Turns unit on/ off
WI-FI OPERATING
STATE
TEMPERATURE
UP
TEMPERATURE
DOWN
TIMER
shows on or off
FILTER
Check / clean
7