Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
D
Secure the projector to the setting plate
(1) Loosen the two screws and remove the cable cover from the projector.
(2) Insert the slide plate into the setting plate from the interface side of the projector (
Align the marks on the projector and the setting plate (
Slide plate
Projector
interface side
(3) Tighten the two M5 x 12 mm hexagon socket head cap bolts (
Warning
If you use adhesives to prevent the screws from loosening or things such as lubricants or oils
on the slide plate, the case may crack and cause the projector to fall, resulting in personal
injury or property damage. Do not use adhesives, lubricants, or oils to install or adjust the
setting plate.
Screws (2)
20
Cable cover
B
).
M5 x 12 mm hexagon
socket head cap bolts (2)
Marks
C
).
A
).
Bolt positions
Publicité
Table des Matières
