Table Des Matières - Wurth Master DIGA CSM-1 Notice D'utilisation

DIGA CSM-1.book Seite 12 Freitag, 15. August 2008 1:20 13
Intended Use
The unit is intended to fasten bolts (fasteners) in con-
crete, solid lime-sand stone, solid brick wall and
steel, when using original Würth system accessories.
For damage caused by usage other then intended,
the user is responsible.
Functional Principle
The bolt-firing tool DIGA is equipped with a com-
bustive power source, for which an explosive gas
mixture is ignited and a piston for driving in the fa-
stening bolt/brad is powered.
The combustion process produces exhaust gas and
noise emissions that can be harmful to one's health.
The specified safety measures are to be observed.
Due to the design of the tool, it is not classified as a
fastening tool in accordance with class A of BGV. It
is recommended to observe BGV A.
Machine Elements
1 Air-intake opening/lid with filter mat
2 Housing
3 Locking latch
4 Neck-down sleeve/firing safety
5 Release lever
6 Tensioning slider
7 Exhaust outlet
8 Trigger
9 Magazine
10 Magazine base
11 Fastening-element stop
12 Belt holding bracket
13 Battery
14 Battery unlocking button
15 Control indicator for charge condition of
battery
16 Cover/port for gas cartridge
Not all of the accessories illustrated or described are included
as standard delivery.
12
Tool Specifications
Bolt-firing Tool
Article number
Shooting capacity (max.)
Brad-length x brad-Ø (max.)
Magazine capacity
Dimensions
(height x length x width)
Weight
Gas Cartridge
Article number
Quantity
Contents
Danger classification
Max. ambient temperature
Spare energy capacity
Power Supply
Input voltage/current
Output voltage/current
Charger
Input voltage/current
Output voltage/current
Charging time
battery empty
initial starting of operation
Battery
Rated voltage
Capacity
Ambient temperature
Spare energy capacity
(battery fully charged)
Battery and Charger
Charging the Battery
Prior to the initial starting of operation as well as after
longer periods of non-usage, the battery must be char-
ged for 24 hours in order to reach its full capacity.
To remove the battery from the tool, fully press in
both unlocking buttons 14.
Plug the power supply into the power outlet and the
charge connector into the socket of the charger. The
charging procedure begins as soon as the battery is
placed into the charger cradle. During charging, the
battery as well as the charger warm up, which is normal.
Control Indicators
For control of the charging condition, the charger is
equipped with a red and a green LED indicator:
green LED lights up:
Charger is ready for operation; battery is fully
charged.
DIGA CSM-1
086494
1000 h
19 - 65 mm x
2.6 - 3.7 mm
40 pcs.
467 x 122 x 450 mm
4.4 kg
864 900 0 ...
80 ml
Isobutene/Propane
2.1 UN 1950 F+
50 °C
approx. 800 shots
100 - 240 V≈/0.4 A
12 V =/1.2 A
12 V =/1.2 A
10 V =/0.8 A
120 min
24 h
NiMH
6 V =
1.5 Ah
5 - 50 °C
approx. 3000 shots