ZEKLER 412 S Instructions D'entretien page 7

User manual / GB
Parts (pic. A)
A:1. Headband of thermo plastic
A1a. Helmet/Cap attachment of thermo plastic
A1b. Housing of thermo plastic
A1c. Steel spring (inside)
A:2. Stirrup attachment
A:3. Replaceable foam filled ear cushions
A:4. Replaceable foam filled head cushion
A:5. Connection cable between left and right ear cups
A:6. LED light
A:7. Volume DOWN
A:8. On/Off button
A:9. Volume UP
A:10. Speech microphone
A:11. Charging socket
Accessories and spare parts (pic. B)
B:1. Hygiene kit: 380684118
B:2. USB charging cable: 380684100
Change of hygiene kit (pic. D)
1. Remove the old sound absorbing foam and insert the new.
2. Pull off the old ear cushion.
3. Centre the new ear cushion over the hole.
4. Press with a finger along the outside of the ear cushion until it attaches all around the edges.
5. Pull off the old head cushion and insert the new.
Approval and technical data (E)
E:1) Headband
E:2) Helmet/Cap mounted
E:3) Tested and certified to (standards)
E:4) Weight
E:5) Mean attenuation
E:6) Standard deviation
E:7) Assumed Protection Value
E:8) Tested and certified by (notified body)
E:9) Size: S,M & L
Bluetooth® Standard 4.1 (no Smart/BLE-support)
A2DP 1.2, HSP 1.1, HFP 1.6
Approved helmet combinations
These earmuffs should be fitted to, and used only with the industrial safety helmets listed in table G.
G:1) Manufacturer
G:2) Model
G:3) Adapter
Earmuffs complying with EN 352-3 are of medium size range or small size range or large size range. Medium size range
earmuffs will fit the majority of wearers. Small size range or large size range earmuffs are designed to fit wearers for whom
medium size range earmuffs are not suitable.
Hereby, Zekler Safety, declares that the hearing protector Zekler Streaming is in compliance with PPE Directive 89/686/EEC,
PPE regulation EU 2016/425 and the RED Directive 2014/53/EU. The full text of the EU declaration of conformity is available at
the following internet address: www.zekler.com/Declaration-of-conformity
For traceability, refer to the serial number label placed on the inside of the headband or helmet attachment arm.
This product is covered by the Waste Electrical and Electronic Equipment directive (WEEE) 2012/19/EU.
Do not dispose your product as unsorted municipal waste. Battery must be disposed of in accordance with national regulation.
Use local recycling system for electronic products.
7