Elcometer 319 S Guide D'utilisation page 18

10 BATCHING - MODEL T (continued)
To create an 'Interval Logging' batch:
1 Press Menu/Batch/New Batch.
2 If 'Interval Logging Batch' is not
displayed on screen, press the
softkey to select 'Interval Logging'
followed by 'Ok'.
The icon will be displayed on the main
4
reading screen indicating that 'Interval
Logging' is enabled.
é ê
3 Use the
required time interval, between
1 second and 24 hours, followed by
'Ok' to set.
The approximate number of readings which
4
can be taken and saved in the batch
together with the approximate number of
days it will take to take those readings at the
time interval set is displayed.
4 If required, use the
the required delayed start time,
between 1 and 60 minutes or 'Off',
followed by 'Ok' to set.
5 Press 'Start' to initiate logging.
If a delayed start time has been set, the
4
countdown will begin when 'Start' is pressed.
The icon will be displayed on screen,
changing to
elapsed and the gauge starts logging
readings.
When a batch is open, the 'Batch' softkey is replaced by
4
to return to the Batch Menu.
www.elcometer.com
sofkeys to set the
é ê
sofkeys to set
when the set delay has
R
. Press
en-16