Cleaning And Maintenance; After-Sales Service - EWT RB2M Mode D'emploi

PL
environment. When disposing of the appliance, the
e when batteries must be removed from the remote control and
be set disposed of in an appropriate place - Please refer to
recycling section.
switch

CLEANING AND MAINTENANCE

eaches
Switch off the appliance first and disconnect the plug from
the socket.
nce on • Clean the housing with a moist cloth, vacuum cleaner or
t up on brush.
• Do not use any abrasive or caustic cleaning agents.
• Do not use any flammable cleaning agents e.g. petrol or
spirit for cleaning the appliance.
nected • Never immerse the appliance in water.
llowing • Air inlet and outlet area should be cleaned with a vacuum
cleaner regularly·
• If the appliance is not used for extended periods, it must
n your be protected against excessive dust and dirt.
control RECYCLING
For electrical products sold within the European
Community. At the end of the electrical products
useful life it should not be disposed of with
f household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling
advice in your country.
ng and
Batteries should be disposed of or recycled in accordance
with WEEE Directive 2012/19/ EU. Packaging should be
recycled where possible.
ion
consult
the lid
egative
of your
o fall to
for the
RB2M.indd 7
UK DE
AFTER SALES SERVICE
Should you require after sales service please contact the
retailer from whom the appliance was purchased or contact
the service number relevant to your country on the warranty
card.
Please do not return a faulty product to us in the first
instance as this may result in loss or damage and delay in
providing you with a satisfactory service.
In the interests of further development, the appliance may
be subject to constructional or design changes without prior
notice.
Please retain your receipt as proof of purchase.
INFORMATION REQUIREMENTS APPLYING TO PORTABLE
ELECTRICAL HEATING DEVICES
MODEL IDENTIFIER
Heat output
Nominal heat output
Minimum heat output
(indicative)
Maximum continuous heat
output
Auxiliary electricity Consumption
At nominal heat output
At minimum heat output
In standby mode
Type of heat output / room temperature control
Electronic room temperature control
FR IT NL PL
RB2M
Pnom 2.2 kW
Pmin 0 kW
Pmax,c 2.2 kW
elmax N/A kW
elmin N/A kW
elSB 0.002 kW
Yes
7
11/06/19//24 13:57