LEXIBOOK SW100MI Mode D'emploi page 6

Note: The direction of the needle must be correct, and the screw against
the needle must be properly tightened to keep the needle from falling out.
USING THE FOOT PEDAL:
The foot pedal switches the machine on and off using your foot, allowing you to use both hands to control the fabric.
Insert the plug at the end of the foot pedal's cord into the foot pedal socket, found below the hand wheel. The machine
needs to be in the "Off" position.
Note: Be sure to press the On/Off switch to the "Off" position when finished sewing to avoid accidentally starting
the machine.
LAMP CONTROL:
Press the lamp switch to turn the lamp on if you need more light.
THREAD CUTTING FUNCTION:
The thread cutter above the lamp allows you to conveniently cut threads without scissors. Tightly pull the thread down
across the cutter.
COMMON PROBLEMS AND SOLUTIONS
PROBLEM POSSIBLE CAUSE
DESCRIPTION
POWER OFF (SLOW Incorrect battery direction
RESPONSE
Exhausted batteries
Mixed new and old batteries
Insufficient output power of the external
power source, low output voltage or
damaged power source
THREAD SKIPPING Leaning needle hole, inadequate
installation of the needle
Bent or deformed needle
Presser foot loose
THREAD FAILURE Incorrect thread sequence
Bottom thread exhausted
THREAD Bobbin of bottom thread jamming
BREAKAGE
Burr in the needle hole
Leaning needle or inadequate installation
Hindered movement of the surface thread
BAD BOTTOM
THREAD OR
SURFACE THREAD
Surface thread too tight or too loose
Bent or deformed needle
Incorrect threading
Loosening of the presser foot or the
NEEDLE BUMPING
needle
Drag the cloth during the sewing operation
No cloth in place when switching to "On"
SAFETY INSTRUCTIONS
PLEASE READ BEFORE OPERATING THIS EQUIPMENT.
Before using the unit, be sure to read all operating instructions carefully. Please note that these are general precautions
and may not pertain to your unit.
1. Read this Instruction Manual before you attempt to connect or operate the appliance.
2. Keep these instructions in good condition. Heed all warnings. Follow all instructions.
3. Save this Instruction Manual for future reference.
SOLUTIONS
Place the batteries in the correct direction
Change to new batteries
Change to all new batteries
Change to a suitable power source
Change the needle
Change the needle
Tighten the presser foot screw
Thread again in the correct sequence
Change the bobbin of the bottom thread
Check if the end of the thread in the bottom
thread bobbin has been cleared
Change the needle
Install the needle again
Check if the bobbin of surface thread and the
spindle are spinning freely
Turn the adjusting know of the surface thread to
make the bottom thread and the surface thread
even
Change the needle
Thread again in the correct sequence
Change the needle and tighten the presser foot
screw
Change the needle and thread again to sew
Change the needle and thread again to sew
4. The apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall
be placed on the product. Dry location use only.
5. No naked flame source, such as candles, should be placed on the product.
6. Children should be supervised to ensure that they do not play with the appliance.
7. Ventilation should not be impeded by covering the ventilation openings.
8. Only use accessories, which are specified by the manufacturer.
9. Use replacement parts, which are specified by the manufacturer.
10. Install the unit in accordance with the manufacturer's instructions.
11. Place the unit where there is good ventilation. Place the system on a flat, hard and stable surface. Do not expose
to temperatures above 40°C. Allow at least 10 cm clearance from the rear and the top of the unit and 5 cm from
each side.
12. Dispose of used batteries in an environmental-responsible manner.
13. Always ensure that the product is unplugged from the electrical outlet before moving or cleaning. Clean it with dry
cloth only.
14. Turn off the product during lightning, storms or when it will not be used for long periods of time.
15. This product has no user-serviceable parts. Do not attempt to repair this product yourself. Only qualified service
personnel should perform servicing. Take the product to the electronics repair shop of your choice for inspection
and repair.
16. NEVER let anyone, especially children, push anything into holes, slots or any other openings in the unit's casing as
this could result in a fatal electric shock.
17. Do not place the unit near TVs, speakers and other objects that generate strong magnetic fields.
18. Do not leave the unit unattended when it is in use.
19. Keep minimum distances around the apparatus for sufficient ventilation.
20. The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers,
tablecloths, curtains, etc.
21. The use of apparatus in tropical and/or moderate climates.
22. Batteries should be disposed properly. Take them to the collection container in order to protect the environment.
MAINTENANCE AND WARRANTY
NOTE: Please keep this instruction manual, it contains important information.
This product is covered by our 2-year warranty.
For any claim under the warranty or after sale service, please contact your distributor and present a valid proof of pur-
chase. Our warranty covers any manufacturing material and workmanship defect, with the exception of any deterioration
arising from the non-observance of the instruction manual or from any careless action implemented on this item (such as
dismantling, exposition to heat and humidity, etc.).
It is recommended to keep the packaging for any further reference.
• Do not attempt to sew thick materials or force the hand wheel.
• Change the batteries when you notice that the machine is working at a slower speed than usual.
• To clean the machine, use only a dry cloth; do not use any detergent product.
Environmental Protection
• Unwanted electrical appliances can be recycled and should not be discarded along with regular household waste!
Please actively support the conservation of resources and help protect the environment by returning this appliance
to a collection centre (if available).
• Do not expose the machine to direct sunlight or to any other source of heat.
• Do not dismantle or drop.
WARNING: This product contains functional sharp edge on scissors and functional sharp point on needle and should be
used under the
direct supervision of an adult.
WARNING: To be used under the direct supervision of an adult. Do not touch sharp needle end or scissor blade as it may
cause injury.
WARNING. Not suitable for children under 3 years. Choking Hazard – Small parts.
In a bid to keep improving our services, we could implement modification on the colours and the details of the product
shown on the packaging.
Reference: SW100MI
Designed and developed in Europe - Made in China.
© LEXIBOOK®
United Kingdom & Ireland
For after-sales service, please contact us at savcomfr@lexibook.com.
www.lexibook.com
Environmental Protection
Unwanted electrical appliances can be recycled and should not be discarded along with regular household
waste! Please actively support the conservation of resources and help protect the environment by returning
this appliance to a collection centre (if available).
Follow us
@LexibookCom
Lexibook UK
PO Box 59
SOUTH MOLTON
EX36 9AU
UK