Fault/Error Codes - Whirlpool W10441082B Manuel D'instructions

FOR SERVICE TECHNICIAN'S USE ONLY

FAULT/ERROR CODES

(Refer to fault/error code charts on pages 8–10.)
Fault/Error Code Display Method
Fault codes are displayed by alternately
showing F# and E#. All fault codes have an
F# and an E#. The F# indicates the suspect
System/Category. The E# indicates the
suspect Component system.
Up to four Fault/Error codes may be stored.
When the oldest fault code is displayed, the
following press of the 3rd button will result
in a triple beep, then display of the most recent
fault code. If each press of the 3rd button
results in a triple beep and the display shows
"888" or "88", no saved fault codes are
present.
Entry Procedure
To display the Fault/Error Codes, press and
release the 3rd button used to activate the
Service Diagnostic mode.
Advancing Through Saved Fault/
Error Codes
Procedure for advancing through saved
fault codes:
Press and release g beep tone g most recent fault
the 3rd button
used to activate
Service Diagnostics
Repeat g beep tone g second most
Repeat g beep tone g third most
Repeat g beep tone g fourth most
Repeat g triple beep g back to the most
DO NOT REMOVE OR
code is displayed.
recent fault code
is displayed.
recent fault code
is displayed.
recent fault code
is displayed.
recent fault code.
DESTROY
Clearing Fault Codes
To clear fault codes, enter Service Diagnostic
mode. Then press and hold the 3rd button
used to enter Service Diagnostic mode
for 5 seconds. Once the fault codes are
successfully erased, the seven segment
display will show "888" or "88".
Exit Procedure
To exit Fault/Error Codes, press and hold the
1st button used to activate Service Diagnostic
mode for 5 seconds.
PAGE 7