Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fitting the inlet Ø 180 mm
How to proceed:
1. Insert the seal in the container wall from the outside.
2. Place the inlet on the seal.
– Ensure that the marking points up and is aligned with the holes in the container wall.
3. Use three oval head screws to screw the inlet to the container wall.
– Tighten the screws diagonally to ensure that the seal is uniformly applied.
– If you are using a cordless screwdriver: Do not set the screwdriver to "drill" to prevent dam-
age to the self-tapped thread. Then re-tighten the screws with a Torx screwdriver.
4. Push the rubber socket over the inlet and fasten it with the hose clip.
– Turn the hose clip so that the screw is accessible from the side. This facilitates later installa-
tion work.
26
Proficlear0295
Publicité
Table des Matières
