Malfunctions And Troubleshooting - Beem F200-A1 Mode D'emploi

NOTE: do not use any solvents or abrasive cleaning products such as scouring
milk or powder.
ATTENTION: never wash the milk container in the dishwasher.
Never rinse the outside of the milk container under running water. Never
immerse the milk container in water.
8

Malfunctions and troubleshooting

DANGER: pull out the mains plug in the event of malfunctions during operation.
Fault
Signal lamp does not light
up
The appliance does not
produce milk froth.
BEEM – Elements of Lifestyle
Possible cause
Mains plug not inserted
No mains voltage
On/Off switch faulty
Signal lamp defective
The whisk head is not in
place properly on the shaft
inside the milk container.
The whisk head is blocked
by milk residue or any
objects.
The whisk head is
defective.
Remedy
Connect appliance to the
power supply
Check main fuse/power
socket
Inform customer service
Inform customer service
Push the whisk head down
firmly on the shaft inside
the milk container.
Check the whisk head and
clean it, if necessary.
Remove the objects.
Inform customer service
Seite/Page/Page/Página
21 / 48