Oscartielle Guam Mode D'emploi Pour L'utilisateur page 16

Warning: If the unit doesn't cool the products enough:
- Check that the condenser is clean and capable of exchanging the heat; otherwise, see point 11.
- Check that the unit has been loaded properly and that the air intake isn't blocked; otherwise, see point 7.
- Check that the unit evaporator (TN versions) isn't covered with ice; otherwise, see point 11.
- Check that the unit isn't close to strong air flows or heat sources (see point 4).
- Check that the unit is leveled and that the environmental conditions meet those indicated in point 4.
If the problem persists despite the above checks, contact your nearest service centre.
Warning: Never approach the motor compartment in the event of leaking gas or a fire. Unplug at the mains. Never use water to put out
any flames, but only dry powder extinguishers. All the materials used to build the unit are fire-proof or self-extinguishing and non-
flammable.
13 - Accessories
The GUAM combined unit can be fitted with the following accessories on request:
1. Night cover
2. Adhesive price indicators (40 mm)
3. High and low row dividers
4. Defrosting resistances for upper section (GUAM BT-TN only - fitted as standard on GUAM BT-BT versions)
To purchase any of the above accessories, contact your nearest OSCARtielle dealer or OSCARtielle SpA directly. Only OSCARtielle
Customer Service is allowed to fit the defrosting resistances.
14 - Customer service
In case service is required and/or mechanical, electrical or compressor components need to be replaced, please contact the dealer from
whom you purchsed the unit and ask for original spare parts.
15 - Decommissioning and scrapping
Divide the various parts of the unit up for scrapping and/or recycling in compliance with local laws and in full respect of the environment.
No part making up the unit should be disposed of as normal urban waste, except for those metal parts that are not considered "special
waste" in the majority of countries of destination. The components of the refrigerating circuit (i.e. coolant gas and lubricating oils) must
not be disposed of freely in the environment, but sent to specialised waste recovery centres.
16 - Manufacturer's statement (Start-up prohibition)
The above models are also built to be assembled in-line with other items of machinery to produce a machine, as defined by EEC
Directive 89/392.
Therefore, the Manufacturer hereby states that it not permitted to start the unit up until the machine in which it is incorporated (or it will
become a part of) has been identified and its compliance with the provisions of EEC Directive 89/392 and applicable national laws has
been stated. In other words, until the machine referred to in this statement becomes one with the final machine.
17 - Wiring diagrams
The wiring diagram for the electronic control is attached to the manual. The derivations
14