Hoover HNFTS S684TAH-01 Mode D'emploi page 59

RAPID / STAIN LEVEL button
This button allows you to choose between
two different options, depending on the
selected programme.
- RAPID
The button becomes
you select the RAPID (14/30/44 Min.)
programme on the knob and allows you to
select one of three durations indicated.
- STAIN LEVEL button
l
Once the programme has been selected
the wash time set for that programme will
be automatically shown.
l
This option allows you to choose between
3 levels of wash intensity modifying the
length of the programme, depending on
how much the fabrics are soiled (can only
be used on some programmes as shown
in the table of programmes).
TEMPERATURE SELECTION button
l
This button allows you to change the
temperature of the wash cycles.
l
It is not possible to raise the temperature
over the maximum allowed for every
programme, in order to save the fabrics.
SPIN SELECTION button
l
By pressing this button, it is possible to
reduce the maximum speed, and if you
wish, the spin cycle can be cancelled.
l
If the label does not indicate specific
information, it is possible to use the
maximum spin expected in the program.
To prevent damage to the fabrics, it is
not possible to increase the speed
over the maximum allowed for the
programme.
l
To reactivate the spin cycle press the
button until you reach the spin speed you
would like to set.
l
It is possible to modify the spin speed
without pausing the machine.
active when
An over dosing of detergent can
cause
appliance detects the presence of
excessive foam, it may exclude the
spinning phase or extend the duration
of the program and increase water
consumption.
The machine is fitted with a special
electronic device, which prevents the
spin
particularly unbalanced load. This
reduces the noise and vibration in the
machine and so prolongs the life of
your machine.
ACTIVE STEAM button
This button allows a specific treatment to
follow certain wash cycles (please refer to
the program table).
The steam function works by relaxing
creases in wet garments and as a
result reduces the time needed to iron
these items.
The fibres are regenerated and refreshed
by removing bad smells.
Every program provides a dedicated steam
treatment in order to ensure the maximum
cleaning efficiency according to the items
fabric type and colour.
This option must be selected before
pressing the START/PAUSE button.
59
excessive foaming.
cycle without load
If the
or on