DRIVE OVERVOLTAGE
Condition
Action
Exit
DRIVE OVERHEAT
Condition
Action
Exit
DRIVE OVERLOAD
Condition
Action
Exit
DRIVE GROUND FAULT
Condition
Action
Exit
DRIVE LOW VOLTAGE
Condition
Action
Exit
DRIVE INTERNAL
Condition
Action
Exit
DRIVE EXCEPTION
Condition
8514-291-001 REV E PAGE 30
This error occurs when the control receives a message that the drive has
experienced an over voltage condition.
When detected, the control turns off the motor and the heating relay. There is
no delay in the action once the criteria are met.
The machine will not start, and the Error Code will continue to be displayed
until the condition no longer exists and the prompt is followed to Reset the
Error Code and return the Machine to Idle Mode.
This error occurs when the control receives a message that the drive has
experienced an overheat condition.
When detected, the control turns off the motor and the heating relay. There is
no delay in the action once the criteria are met.
The machine will not start, and the Error Code will continue to be displayed
until the condition no longer exists and the prompt is followed to Reset the
Error Code and return the Machine to Idle Mode.
This error occurs when the control receives a message that the drive has
experienced an overload condition.
When detected, the control turns off the motor and the heating relay. There is
no delay in the action once the criteria are met.
The machine will not start, and the Error Code will continue to be displayed
until the condition no longer exists and the prompt is followed to Reset the
Error Code and return the Machine to Idle Mode.
This error occurs when the control receives a message that the drive has
experienced a ground fault condition.
When detected, the control turns off the motor and the heating relay. There is
no delay in the action once the criteria are met.
The machine will not start, and the Error Code will continue to be displayed
until the condition no longer exists and the prompt is followed to Reset the
Error Code and return the Machine to Idle Mode.
This error occurs when the control receives a message that the drive has
experienced a low voltage condition.
When detected, the control turns off the motor and the heating relay. There is
no delay in the action once the criteria are met.
The machine will not start, and the Error Code will continue to be displayed
until the condition no longer exists and the prompt is followed to Reset the
Error Code and return the Machine to Idle Mode.
This error occurs when the control receives a message that the drive has
experienced an internal error.
When detected, the control turns off the motor and the heating relay. There is
no delay in the action once the criteria are met.
The machine will not start, and the Error Code will continue to be displayed
until the condition no longer exists and the prompt is followed to Reset the
Error Code and return the Machine to Idle Mode.
This error occurs when the control receives a message that the drive has
logged an exception code.