Dexter Laundry T-30 Manuel De L'utilisateur page 28

TEMP SENSOR OPEN
Condition
Action
Exit
NO HEAT RISE
Condition
Action
Exit
HEAT RISE OUT OF RANGE
Condition
Action
Exit
CONTROL BOARD ERROR XX
Condition
Action
Exit
GRAPHICS BOARD
Condition
Action
Exit
MODEL JUMPER MISSING
8514-291-001 REV E PAGE 28
machine still will not start, and the Error Code will continue to be displayed until
the prompt is followed to Reset the Error and return the machine to Idle Mode.
This error occurs when the control detects an open circuit from the
temperature sensor.
When detected, the control turns off the motor and the heating relay. There is
no delay in the action once the criteria are met.
The machine will not start, and the Error Code will continue to be displayed
until the condition is no longer present. Once the condition is removed, the
machine still will not start, and the Error Code will continue to be displayed until
the prompt is followed to Reset the Error and return the machine to Idle Mode.
This error occurs when the control detects that the temperature is not
increasing.
When detected there is a delay of 15 minutes before the error is active. Once
active, the control will display the "NO HEAT RISE" prompt, alternating with the
normal Cycle Progress screen at a rate of 5 seconds on, 5 seconds off. The
heating relay will also be turned off. Otherwise the cycle will continue normally.
The Error Code will continue to be displayed until the in-progress cycle is
stopped and the control is returned to Idle Mode. It will then reset
automatically.
This error occurs when the control detects that the operating temperature is
greater than 220 degrees F (or 104 degrees C).
When detected, the control will display the "HEAT RISE OUT OF RANGE"
prompt, alternating with the normal Cycle Progress screen at a rate of 5
seconds on, 5 seconds off. The heating relay will also be turned off. Otherwise
the cycle will continue normally. There is no delay in the action once the
criteria are met.
The Error Code will continue to be displayed until the in-progress cycle is
stopped and the control is returned to Idle Mode. It will then reset
automatically.
This error occurs when the Main Control Board cannot command the input and
outputs of the control system as required by the cycle programming.
When detected, the control turns off the motor and the heating relay. There is
no delay in the action once the criteria are met.
The machine will not start, and the Error Code will continue to be displayed
until the prompt is followed to Reset the Error Code and return the Machine to
Idle Mode. If the prompt to Reset is not available, power must be cycled to the
machine to reset the error.
This error occurs when the Graphics Board cannot command the Main Control
board as required by the cycle programming.
When detected, the control turns off the motor and the heating relay. There is
no delay in the action once the criteria are met.
The machine will not start, and the Error Code will continue to be displayed
until the prompt is followed to Reset the Error Code and return the Machine to
Idle Mode. If the prompt to Reset is not available, power must be cycled to the
machine to reset the error.