Blowing Function; Technical Specifications; Care And Maintenance - Kärcher WD 3 Mode D'emploi

Working with electrical power tools
Illustration
 Adapt the adapter to the connection diameter of the
electric tool using a knife if necessary.
 Connect the adapter to the handle of the suction
hose and connect it to the electric tool connection.
Connect the mains plug of the electric power tool to
the vacuum cleaner.
Illustration
 Switch the vacuum cleaner to Position II and start
working.
Note: As soon as the electric tool is switched on, the
suction turbine starts with a 0.5 second delay. If the
electric tool is switched off, the suction turbine contin-
ues to run for approx. 5 seconds in order to vacuum up
the remaining dirt in the suction hose.

Blowing function

Cleaning hard to reach locations or, where vacuuming
is not possible, like leaves from a gravel bed.
Illustration
 Connect the suction hose to the blower connection,
this will activate the blower function.
Interrupting operation
 Turn off the appliance.
Illustration
 Hook the floor nozzle into the parking position.
Finish operation
 Turn off the appliance and disconnect the mains plug.
Empty the container
Illustration
 Remove the appliance head and empty the reservoir.
Storing the appliance
Illustration
 Stow away the mains cable and accessory at the
machine. Store the appliance in a dry room.

Care and maintenance

 Clean the appliance and accessory parts made of
plastic with a commercial plastic cleaner.
 If required, rinse the container and accessories
with water properly and dry them before reuse.
Illustration
 Only clean the cartridge filter under running water;
do not wipe or brush. Let it dry completely prior to
installation.
12
Troubleshooting
Decreasing cleaning power
If the cleaning power of the appliance deteriorates
please check the following:
 Accessories, suction hose or suction pipes are
clogged, please remove the obstruction using a
stick.
Illustration
 Filter bag is full, install new filter bag.
Illustration
 Cartridge filter is dirty, knock off dirt from cartridge
filter and clean under running water if necessary.
 Replace damaged cartridge filter.

Technical specifications

The Specifications are listed on page IV. The following
is an explanation of the symbols.
Voltage
Output P
Max. connection output of appliance socket
Mains fuse (slow-blow)
Container capacity
Water intake with handle
Water intake with floor nozzle
Power cord
Sound pressure level (EN 60704-2-1)
Weight (without accessories)
Subject to technical modifications!
– 8
EN
nom