Safety Instructions; Function; Start Up; Operation - Kärcher PW 30/1 Mode D'emploi

Safety instructions

Danger
Never spray and vacuum up explosive
–
liquids, combustible gases, explosive
dusts as well as undiluted acids and
solvents! This includes petrol, paint
thinner or heating oil which can gener-
ate explosive fumes or mixtures upon
contact with the suction air. Acetone,
undiluted acids and solvents must also
be avoided as they can harm the mate-
rials on the machine.
Switch off the appliance prior to clean-
–
ing and performing any maintenance
tasks or replacing parts. In case of
mains operated appliances, remove the
mains plug; in case of battery-operated
appliances, pull out the battery plug or
clamp off the battery. Shut the device
off when switching to a different func-
tion.
Make sure that the power cord or exten-
–
sion cables are not damaged by run-
ning over, pinching, dragging or similar.
Protect the cable from heat, oil, and
sharp edges.
The power cord must be checked regu-
–
larly for damages, such as cracks or ag-
ing. If damage is found, the cable must
be replaced before further use.
The appliance may only be used by per-
–
sons who have been instructed in han-
dling the appliance or have proven
qualification and expertise in operating
the appliance or have been explicitly
assigned the task of handling the appli-
ance.
Please keep in mind that the power
–
cord or extension cable can be dam-
aged when run over while operating the
cleaning head with rotating brushes/
disks.
Maintenance work may only be carried
–
out by approved customer service out-
lets or experts in this field who are famil-
iar with the respective safety
regulations.
8
With the PW 30/1, the dirt is brushed out of
the carpet by a rapidly running brush in ad-
dition to the spray extraction process. This
allows a thorough cleaning of even severe-
ly soiled carpets.
 Get the washing vacuum Puzzi ready to
operate.
 Connect the spray/suction hose and to
the appliance (Fig. A, B).
 Connect the PW 30/1 to the spray/suc-
tion hose (Fig. C). Ensure that the cou-
plings of the pressure hose lock in.
Using the additional socket:
1 Slide the protective cover into the direc-
tion of the arrow with the PW 30/1 appli-
ance plug.
2 Insert the PW 30/1 appliance plug into
the auxiliary socket of the washing vac-
uum Puzzi.
3 Operate the PW 30/1 as per the operat-
ing instructions.
Turning on the Appliance
 Start up the washing vacuum Puzzi.
 Start the brush drive on the appliance
switch of the PW 30/1 (Fig. D).
Note: The brush drive will stop when the
brush is blocked. For troubleshooting in-
structions see "Fault assistance".
 Use the valve handle (Fig. E).
This will spray on the detergent solution.
The wastewater will be immediately vacu-
umed back up via the suction nozzle.
 Pull the PW 30/1 backwards in slightly
overlapping runs over the carpet.
 Start in location so that you will not have
to walk on already cleaned areas.
 Release the valve handle while driving
forward (empty lift).
– 2
EN

Function

Start up

Operation

Cleaning