Transport; Storage; Maintenance And Care; Troubleshooting - Kärcher PW 30/1 Mode D'emploi

Turning Off the Appliance
 Switch the brush drive off at the appli-
ance switch.
 Shut off the washing vacuum Puzzi.

Transport

Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 Pull the appliance behind you by the
suction pipe for transporting it over
longer distances.
 Grab the appliance by the casing and
the suction pipe to transport it.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.

Storage

Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Maintenance and care

After each operation
 Rinse the PW 30/1 with clear water.
 Clean the brush roller of lint and dirt.
 Check the spray pattern of the nozzle
mouth piece; if it is irregular, clean the
nozzle and the mouthpiece.
 Clean the suction hose and nozzles if
the suction performance is reduced.
Half-yearly
 Check the toothed gear wear and the
tension, replace if required.
 Check brush wear, replace brush if re-
quired.
Maintenance Works
Replacing the brush roller
 Loosen the 5 screws and remove the
hood.
 Remove the toothed belt.
 Unscrew and withdraw the bolt on the
front of the brush.
 Remove the holding plate on the oppo-
site side by removing three screws and
take the brush out.
 Assembly of the brush in reverse se-
quence.

Troubleshooting

Brush is blocked
Note: If the brush is blocked, the brush mo-
tor is shut off.
 Switch the brush drive off at the appli-
ance switch.
 Check brush to see if there are impuri-
ties and remove blocking objects, if any.
 Remove the safety cap and press the
safety switch by means of a screwdriver.
 Reinstall the safety cap.
The warranty terms published by the rele-
vant sales company are applicable in each
country. We will repair potential failures of
your appliance within the warranty period
free of charge, provided that such failure is
caused by faulty material or defects in man-
ufacturing. In the event of a warranty claim
please contact your dealer or the nearest
authorized Customer Service centre.
Please submit the proof of purchase.
– 3
EN

Warranty

9