Dometic AG101 Instructions De Montage page 12

Installation
5 Installation
Observe the following requirements for the installation location:
• The tank must not be placed in the occupant compartment. The tank must not
form a surface (floor, wall, bulkhead) of the occupant compartment or other com-
partment integral with it.
• A partition must be provided to separate the occupant compartment from the
tank. The partition may contain apertures (e.g. to accommodate cables) pro-
vided they are so arranged that fuel cannot flow freely from the tank into the occu-
pant compartment or other compartments integral with it during normal
conditions of use.
• The tank must be fixed securely. Ensure that any fuel leaking from the tank or its
accessories will not escape into the occupant compartment during normal con-
ditions of use.
• The filler hose must not be situated in the occupant compartment, in the luggage
compartment or in the engine compartment.
• The distance between the filler hole and the upper part of the tank must be within
100 mm and 150 mm (fig. 2, page 4).
• The filler cap must not, when closed, project beyond the adjacent surfaces of the
bodywork.
➤ Choose one of the possible installation positions shown in fig. 2, page 4.
➤ Drill holes into the fuel tank depending on the installation position (fig. 3,
page 5 to fig. 6, page 6):
– 25 mm for the connecting hose
– 12 mm for the fuel vapour pipe
– 12 mm for the float
– 9 mm for the fuel intake hose
➤ Connect the fuel intake hose as shown in fig. 7, page 7.
➤ Connect the fuel vapor hose as shown in fig. 8, page 7.
➤ Connect the intake hose as shown in fig. 9, page 8.
➤ Connect the float switch as shown in fig. 0, page 8.
➤ Connect the filler neck as shown in fig. a, page 9.
➤ Follow the instructions in the related manual of the generator for connecting the
grounding and the reserve line input.
➤ Follow the instructions in the related manual of the generator for connecting the
fuel supply to the generator.
12
AG101
EN