Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DE_Log10_20_Anleitung
13.08.2013
LOG10 / LOG20
– Data logger
AVG:
MIN:
Average
Minimum
The display will switch automatically every 10 seconds.
2.4 Display segments of LCD (Fig. 2)
• Besides the two measurements, the large LCD displays several status informa-
tion. By using the Software DE-LOG-Graph you are able to switch on or off the
display, or to setup an interval how long the display will stay on when no but-
ton is pressed (snooze function). By using this function it is possible to prevent
it displaying information to unauthorized persons.
E: Measurement 1
displays the current temperature.
F:
Unit Measurement 1
display the current measuring unit of measurement 1.
G: Measurement 2
displays the temperature measurement, average, minimum or maximum
measurements.
H: Unit Measurement 2
display the current measuring unit of measurement 2.
I:
MAX-MIN-AVG
display the average, minimum or maximum measurements.
J:
Status info
displays the operation mode LOG or STOP. LOG indicates the recording
mode and STOP indicates standby mode.
14
16:02 Uhr
Seite 8
➥
MAX:
AUT:
Maximum
Auto-switch
LOG10 / LOG20
– Data logger
K: Lowbat
indicates the capacity of the battery.
Note: °C = Celsius,°F = Fahrenheit
Other display information
• In addition to the above mentioned information, the display also indicates
several other information. This information will be displayed depending
on the display settings (snooze function) and operation mode:
Display
connected
switched off
to the PC
Logger
Battery
is recording
(total empty)
2.5 LED-Indication
• The LED will help you to understand all logger information, several status
modes and alarm indications.
• LED red:
The red LED flashes when Hi- or Lo-Alarm has been achieved.
Logger
configured
Factory settings
15
Publicité
Table des Matières
