Maintenance; Fixing Problems - Wolf Garten HTA 700 Notice D'instruction D'origine

Maintenance

General
1
Attention! Reverse blade
Before all maintenance and cleaning work:
z Pull out the power plug.
z Do not touch moving blades.

Fixing problems

Problem Possible cause
• Blunt blade.
Blade gets hot.
• Too much friction due to inadequate lu-
Jittery operation, • Blade damaged
heavy vibration
• Blade not firmly in stabilizer.
of the device
• Battery overheating (temperature ex-
Secateurs switch
off inadvertently
• Battery flat
• Battery flat
Secateurs cannot
be switched on
• Battery defective
• Battery temperature below 5 °C or
Charger: No char-
ging (red LED
constantly on)
• Battery defective
Charger: Malfunc- • Contacts dirty
tion (red LED fla-
• Battery defective
shes)
When in doubt, always seek out a WOLF-Garten Service location.
1
Before checking the hedge trimmer or carrying out work on the blade, remove the battery.
16
brication
ceeding 45°C)
above 45 °C
Cleaning
z Clean the hedge shears with a dry towel, par-
ticularly the ventilation slits, after each use or
using a brush in the case of heavy soiling.
z Spray the blades with oil after each use.
z Under no circumstances spray the hedge
shears off with water.
Storage
z Store the hedge shears in the blade scabbard
provided.
z Store the hedge shears in a dry location out of
the reach of children.
Solution
• Go to a WOLF-Garten Service loca-
tion.
• Oil blades
• Go to WOLF-Garten Service location.
• Go to WOLF-Garten Service location.
• Allow battery to cool down
• Recharge battery
• Recharge battery
• Replace battery
• Allow battery to cool down or heat up
• Replace battery
• Clean contacts
• Replace battery
G