Worx WX696L Mode D'emploi page 10

OPERATION INSTRUCTIONS
Note: Before using the tool, read the
instruction book carefully.
Intended Use
The power tool is intended for sawing and
remodeling wooden materials, plastic, plaster, non-
ferrous metals and fasteners (e.g. nails) as well as
for working on soft wall tiles and for dry grinding of
small surfaces. It is especially suitable for working
close to edges and for flush cutting.
Assembly and Operation
ACTION
Mounting Accessories
--Remove the Onboard hex
wrench
--Loosen the flange and
insert accessories
--Tighten the flange
--Store the Onboard hex
wrench
Operating the On/Off Switch
Using the Variable Speed
Dial
10
Remove or Install Battery
Pack
LED Light
The Variable Speed Dial can be used to set the
optimum oscillating frequency according to the
accessories used and the respective application.
Oscillation frequency
High oscillation frequency:
Low oscillation frequency:
20V Cordless Oscillating Tool
FIGURE
See Fig. A
See Fig. B1, B2,
B3
See Fig. C
See Fig. D, E
See Fig. F
See Fig. G
See Fig. H1,H2
See Fig.I
Application
Sanding, sawing,
rasping and
polishing stone
and metal.
Scraping, polish-
ing varnishes.
EN