Maintenance; General Considerations - Samsung FlexWash WV60A9900A Serie Mode D'emploi

Maintenance

Keep the washer clean to prevent its performance from deteriorating and to preserve its life cycle.
WARNING
Certain internal parts are intentionally not grounded and may present a risk of electric shock only during
servicing. Service personnel – Do not contact the following parts while the appliance is energized: Control
board, heat sink, motor, inlet valve and pump.

General considerations

Cleaning
Surface of the washer
Use a soft cloth with a nonabrasive household detergent. Do not spray water onto the washer
Exterior
1. Turn off the water taps after finishing the day's washing. This will shut off the water supply to your
washer and prevent the unlikely possibility of damage from escaping water. Leave the door open to
allow the inside of your washer to dry out.
2. Use a soft cloth to wipe up all detergent, bleach, or other spills as they occur. Clean the following as
recommended below:
- Control panels – Clean with a soft, damp cloth. Do not use abrasive powders or cleaning pads. Do not
spray cleaners directly on the panels.
- Cabinet – Clean with soap and water.
Interior
Clean the interior of your washer periodically to remove any dirt, soil, odor, mold, mildew, or bacterial
residue that may remain in your washer as a result of washing clothes.
CAUTION
Failure to follow these instructions may result in unpleasant conditions, including odors and/or permanent
stains on your washer or laundry.
NOTE
Hard water deposits may be removed, if needed. Use a cleaner labeled "Washer safe".
Untitled-5 59
English 59
2021-06-07 11:22:13