Technical Data - CAME DBC 01 Manuel D'installation

Technical data

DBC 01 (TX)
Power supply: (4 1.5V AAA batteries)
Draw: 70 µA
Degree of protection: IP 54
Material: PC-ABS UL94V0 / Policarbonato / Marpram mar TPA1 65 NT
Working temperature:
DBC 01 (RX)
Power supply: 12/ 24 V A.C. - D.C.
Draw: 48 mA
Degree of protection: IP 54
Material: PC-ABS UL94V0 / Policarbonato / Marpram mar TPA1 65 NT
Working temperature:
RipetitoreDBC 03
Power supply: (4 1.5V AAA batteries)
Draw: 70 µA
Degree of protection: IP 54
Material: PC-ABS UL94V0 / Policarbonato / Marpram mar TPA1 65 NT
Working temperature:
Ripetitore DBC 04
Power supply: (4 1.5V AAA batteries)
Draw: 70 µA
Degree of protection: IP 54
Material: PC-ABS UL94V0 / Policarbonato / Marpram mar TPA1 65 NT
Working temperature:
Dimensions and holes pitch
Receiver/Transmitter/Repeater
Installation
Before installing you must:
• Make sure that the line voltage is disconnected.
• See that the point, to which the equipment will be mounted, is
in an area protected from any impacts, that the mounting surfa-
ce is solid, and that the mounting on to the surface is carried out
with the proper hardware (bolts, pins, etc).
•Provide for proper electrical cable conduits making sure that
they are free from any mechanical damage.
Description/Electrical connections and DIP switch
functions
DBC 01 (TX)
1-Battery housing
(four 1.5V AAA batteries)
2-Infrared led
Fig.B
NO
10
NC
2
Contatto N.O.
C
TS
C1/C2/C3/C4
2
- + - +
K K
K K K K
Fig.A
1
DBC 01 (RX)
2
1-Signal present warning led
2-Dip Switch
Dip Switch function
Dip switch 1 in ON position=
12V AC/DC power supply
3
Dip switch 1 in OFF position=
24V AC/DC power supply
Dip switch 2 in OFF position=
Excludes testing of service
4
function
(to be used when
TS?? Is not connected)
3- Low battery/open contact
warning led
4-Terminal board for con-
nections
1
2