Heathrow Scientific sprout Manuel D'instructions page 3

off during centrifugation and damage the unit. Open lids cancause
fluid to be dispersedinside the centrifuge.
19. Do not insert non-standard tubes or other foreign articles into the
rotor.
20. Follow all precautions from the Material Safety Data Sheet (MSDS) for
any reagent you use with this instrument.
21. Do not use solvent or flammable liquids near this or other electrical
equipment.
22. Do not centrifuge materials that in combination or alone are
flammable, explosive, or corrosive, or may cause any other hazard.
23. Do not operate in a hazardous or flammable environment.
24. Do not use any solvent on the unit that may attack plastic or rubber
or cause cracks in the rotor.
25. Ensure the rotor is protected from corrosion and mechanical damage.
The rotor must be cleaned with a pH-neutral cleaning liquid.
26. Before using any cleaning or decontamination methods except those
recommended in this manual; please contact Heathrow Scientific
LLC to ensure that the proposed method will not damage the device.
27. If a single level of hazard protection is required, make sure to use
containers that are tested to Risk Group II or above and that more
than one level of protection is provided in the case of materials of a
higher Risk Group.
28. Should the unit fail to work to specification, immediately stop
centrifuging and allow the rotor to come to a complete stop. Clean
and troubleshoot the product according to the instructions under
"Trouble Shooting" before any further use of the product. Contact an
authorized dealer or the manufacturer if trouble persists.
29. Always work in a manner which endangers neither the user nor any
other person.
30. Repairs are to be performed by trained and authorized service
personnel only. Contact Heathrow Scientific
31. Opening the instrument housing or improper use of the instrument
voids the warranty. If there is a failure during the warranty period,
contact Heathrow Scientific
32. Do not use units that have not been correctly installed or repaired.
33. Do not attempt to disassemble or modify this product.
34. Store at room temperature in a dry area. Do not expose to sunlight,
moisture, or extreme temperatures for prolonged periods of time.
LLC for warranty service.
®
LLC.
®
®
3