Rega ARIA MK3 Mode D'emploi page 5

SETUP
Separate inputs are used for moving magnet and
moving coil cartridges. Connect your turntable's
tonearm cable to the appropriate input sockets
on the back of the Aria. If your tonearm has a
separate earth, this should be firmly connected
to the earth terminal shown on the rear panel in
the diagram above.
Connect the Aria to your amplifier via the sockets
marked Output to the appropriate line level
input on the back of your amplifier. Use a high
quality phono cable such as the Rega Couple 2
(not supplied). The mains power lead (supplied)
should be connected to the IEC socket on the
right hand side located above the fuse holder.
N.B. Always switch both pre and power amps off
before changing any connections.
BACK PANEL CONNECTIVITY
LOADING SETTINGS (adjustable via back
panel)
LEFT/RIGHT MC LOADING RESISTANCE
1 and 2 off = 400 Ω
1 only on = 100 Ω
2 only on = 150 Ω
1 and 2 on = 70 Ω
CAPACITANCE
3 and 4 off = 1000 pF
3 only on = 2000 pF
4 only on = 3200 pF
3 and 4 on = 4200 pF
LEFT/RIGHT MC GAIN
1 off and 2 on low gain = 63.5 dB
1 on and 2 off high gain = 69.3 dB
WORLD CLASS HI-FI MADE IN ENGLAND | www.rega.co.uk
ARIA
3