Kärcher MV 4 Mode D'emploi page 14

Parking position
Illustration
 To rest the floor nozzle during work in-
terruptions.
Container closure
Illustration
 Pull out to open, push in to lock.
Accessory storage container
Illustration
 This accessory compartment allows the
storage of the suction pipes or other ac-
cessories.
Steering roller
Illustration
 Turn the container, press in the steering
roller in the openings at the base of the
container till the end-point.
Filter bag
Note: Do not use a filter bag for wet vacu-
uming!
Illustration
 Recommendation: To vacuum fine
dust, use the filter bag.
Flat fold filter
(already installed in the appliance)
Caution
Always work with an inserted flat
fold filter - during wet as well as
dry vacuum cleaning!
Suction hose with connecting
piece
Illustration
 Push the suction hose into the connec-
tion on the appliance, it snaps in place.
 In order to disconnect it, push down
with your thumb and pull the suction
hose out.
14
Note: Accessories, such as suction brush-
es (optional) can be directly attached to the
connecting piece and thus connected to the
suction hose.
For convenient working even in tight spac-
es.
The removable handle can be attached be-
tween the accessories and the suction
hose if necessary.
See position 13.
Recommendation: In order to vacuum the
floor, attach the handle to the suction hose.
Removable handle
Illustration
 Connect the handle with the suction
hose until it snaps in place.
Illustration
 To remove the handle from the suction
hose, press the notch using your thumb
and pull off the handle.
Note: Due to removing the handle, acces-
sories can be directly attached to the suc-
tion hose.
See position 12.
Recommendation: In order to vacuum the
floor, attach the handle to the suction hose.
suction pipes 2 x 0.5 m
Illustration
 Put both suction pipes together and
connect them with the handle.
Floor nozzle
(with inserts)
 When vacuuming dry dirt off the floor,
clip an insert with two brush strips into
the floor nozzle.
 When vacuuming water off the floor,
clip an insert with two rubber lips into
the floor nozzle.
Crevice nozzle
 For edges, joints, heaters and hard to
reach locations.
EN
– 8