Dmx Linking - Chauvet Professional STRIKE 4 Guide De Référence Rapide

STRIKE™ 4 QRG
AC Power
Power Linking
AC Plug
Replacing The
Fuse

DMX Linking

DMX Connection
Master/Slave
Connection
This product has an auto-ranging power supply that can work with an input voltage
range of 100–240 VAC, 50/60 Hz.
You can link up to 5 STRIKE™ 4 products at 120 V, 9 products at 208 V, or
10 products at 230 V. Never exceed this number. Power linking cords can be
purchased separately.
Connection
AC Live
AC Neutral
AC Ground
To eliminate unnecessary wear and improve its lifespan, during periods of
non-use completely disconnect the product from power via breaker or by
unplugging it.
1. Disconnect this product from power.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.
The STRIKE™ 4 will work with a DMX controller using a 5-pin DMX serial
connection. A DMX Primer is available from www.chauvetprofessional.com.
The STRIKE™ 4 uses a 5-pin DMX data connection for its DMX personalities:
1 Ch, 3 Ch, 4 Ch and 9 Ch. See the User Manual for information about
connecting and configuring the product for DMX operation.
The STRIKE™ 4 uses the DMX data connection for its Master/Slave mode. See
the User Manual for information about connect and configure the product for
master/slave operation.
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
3
Screw Color
Brown Yellow/Brass
Blue Silver
Green
EN