Coxreels 1125 Serie Manuel D'installation Et D'entretien page 16

EXP-220 (SHEET 2 OF 3)
REVISION: E
ECO NO.:
2961
BY: J. KUSBEL
DATE: 9/04/2013
18
21
23
1 INSTALL AND ALIGN BEARING BLOCK ASSEMBLY, ITEM 3, TO AXLE AND FRAME.
2 INSTALL COATED THRUST WASHER, ITEM 12, ONTO AXLE AND UP AGAINST BEARING BLOCK ASSEMBLY.
NOTE: COATED SIDE OF THRUST WASHER (RED IN COLOR) MUST FACE OUTWARD, AWAY FROM BEARING BLOCK.
3 INSTALL BEARING WASHER, ITEM 7, AND RETAINING RING, ITEM 10, ONTO AXLE.
NOTE: MAKE CERTAIN THAT RETAINING RING IS COMPLETELY SEATED IN AXLE GROOVE.
4. SLIDE AXLE (WITH RETAINING RING AND WASHERS) ALL THE WAY INTO BEARING BLOCK ASSY, ITEM 3, UNTIL IT "BOTTOMS OUT"
IN BEARING BLOCK. MAKE CERTAIN THERE IS A GAP OF 1/16" - 1/8" ON THE OPPOSITE END OF AXLE, BETWEEN THE OPPOSITE
BEARING BLOCK ASSEMBLY, ITEM 4, AND THE OPPOSITE RETAINING RING AND WASHER. SECURE BOTH BEARING BLOCKS TO FRAME.
5 INSTALL BEARING WASHER, ITEM 7, ONTO AXLE AND UP AGAINST RETAINING RING. APPLY A LIGHT COATING OF APPROPRIATE SWIVEL LUBRICANT
TO SEALING SURFACE OF AXLE. VERIFY THAT SWIVEL HOUSING ASSEMBLY HAS BEEN PROPERLY LUBRICATED, AND SLIDE SWIVEL HOUSING
ASSEMBLY, ITEM 11, ONTO AXLE UNTIL FLANGED END OF SWIVEL HOUSING IS SEATED INTO COUNTER-BORE IN BEARING BLOCK ASSEMBLY.
6 INSTALL RETAINING PLATE, ITEM 22, AND MOUNTING HARDWARE ONTO SWIVEL BODY, AND SECURE TO BEARING BLOCK ASSEMBLY.
2
11
5
10
3
22
6
O-RING AND BACKUP RING ARE PART OF ITEM 11,
AND ARE SHOWN FOR REFERENCE ONLY.
20
12
18
7
7
5
3
COXREELS
1195 SERIES MOTORIZED
19
18
3
1
18
19