Monitor Description - golmar Rock Serie Manuel D'installation

68
F
unction push buttons.
On-Off push button. After any monitor reset and during the next 45 seconds, all the
monitor functions will be disabled, with the exception of call reception.
If the handset is on the craddle allows the activation of an optional second camera (*). If
not, allows to make an intercom call or to activate the second camera (*).
If the handset is on the craddle allows the activation of an optional device. If not, allows to
call to a slave porter's exchange (*) or to activate the optional device.
If the handset is on the craddle allows to see the picture from the master door panel. If
not, allows to establish audio and video communication with the door panel that has
been configurated with the autoswitch-on function. This function is disabled if a
communication is already established.
If the handset is on the craddle sends a panic call to the porter's exchanges that have
enabled the reception of this type of call. If not, allows to call to the master porter's
exchange. During call reception and communication progresses allows the lock
release activation.
(*) Second camera activation and call to a slave porter's exchange functions require an internal
modification of the monitor. If any of these functions are required, contact with your nearest
authorized distributor.
Second camera activation disables the intercomm function and call function to a slave porter's
exchange disables optional device function.
D
escription of the identification label.
.xx
INTER A1 SLAVE MASTER
ATENCIÓN
Alta tensión. No abrir la tapa.
Manipular sólo por personal
del servicio técnico.
WARNING
High voltage. Don't open cover.
Handle only by technical service.
REF.
CODE
SN
00000000000
CODE
ESCALERA PISO PUERTA
STAIR FLOOR DOOR

MONITOR DESCRIPTION

For an easiest repair, replacement or increasement of
the existing monitors, fill the indentifying label
information.
MASTER: master monitor.
SLAVE: slave monitor.
INTER: slave monitor with intercom function.
A1: monitor connected to an auxiliary device.
CODE: push button code.
STAIR: backbone code (building) (see pages 65 & 79).