golmar Rock Serie Manuel D'installation page 79

78
P
rogramming the T-740 Plus telephones.
Find the configuration switch located in the rear part of the door panel and
set number 2 to ON.
The door panel will produce a tone, indicating that it has entered program
mode. In systems with more than one door panel, this operation must be
carried out only in the main door panel of each building.
M
CN1 P1
SW1
ON
P3
P2
S
CN1 P1
P2
SI
CN1 P1
P2
Each apartment must have one master unit only; in case of parallel units configure them as slaves,
both monitors or telephones.
Make a call to check that the telephone has been succesfully programmed. Repeat
Once the programming has been finished, set to OFF the programming switch. If
TELEPHONES PROGRAMMING
SW1
1 2
1 2
P3
ON
P3
ON
P3
ON
P3
ON
SW1
P3
ON
P3
ON
SW1
P3
ON
P3
these steps to program the rest of telephones.
you don't, the door panel will reproduce a tone to advise that the system is still
into programming mode.
Open the telephone to programming (see page
P3
77). Select in the SW1 dip switch the fuction
mode for the auxiliary
(see page 76) a
programming push-button.
To show that the system is ready for programming,
the door panel and the telephone's handset will
reproduce a tone (the telephone led will light).
Audio communication can be established.
Press the door panel push button:
At this moment both door panel and handset
will reproduce tones (the telephone led will
slow blink).
To programm the telephone as Master, press the
h ook switch (the telephone led will off).
Close the telephone.
To programm the telephone as Slave, press the
CN1 P1 P1 door release push button (the telephone
led will quick blink) and later press the hook
P2
switch (the led will off).
Close the telephone.
To programm the telephone as Slave +
Intercom., press the P2 auxiliary function
CN1 P1
push button (the led will quick blink) and later
P2
press the hook switch (the led will off).
Close the telephone.
function push button
nd later press the P3