Programming - golmar Rock Serie Manuel D'installation

TELEPHONE PROGRAMMING
P
hone program.
Find the configuration microswitch located in the rear part of the
doorpanel and set number 2 to ON.
The doorpanel will produce a tone, indicating that it has entered
program mode. In systems with more than one doorpanel, this
operation must be carried out only in the main doorpanel of each
Each house must be equipped with just one main unit; if parallel-connected units exist,
they must be configured as slave, whether monitors or phones.
F
inal adjustments
If, when using the device, audio volume is inadequate, it is necessary to carry out some
adjustments, as shown in the picture.
The camera is equipped with an horizontal and vertical orientation device.
If orientation is not correct, change it.
Fix the doorpanel to the embedding box by means of the proper screws.
Press the door opener button and, without releasing it,
lift the handset.
The doorpanel and the handset will produce tones to indicate
that the device is ready to be set up.
It is possible to establish an audio communication.
Release the door opener button.
Make a call to make sure that the phone has been properly set up.
Set up the other phones in the same way.
At the end of the program process, the switch must be set to OFF.
If you forget to do this, the doorpanel will produce tones to indicate that
program mode has not been deactivated.
Press the doorpanel button.
The doorpanel and the handset will
produce tones.
To set up the phone as the main one,
hang the handset up.
To set up the phone as a slave one,
press the door opener button.
51