Water Filtration System - Whirlpool WRS315SDHM Guide D'utilisation

NOTE: Your ice maker has an automatic shutoff to keep the storage
bin from overfilling during normal operation. As ice is made, the ice
cubes will fill the ice storage bin, and the ice cubes will raise the
shutoff arm to the Off (arm up) position. When the storage bin is at full
capacity, the ice maker will automatically stop ice production, but the
ice maker On/Off switch will remain in the On (up) position.
Removing and Replacing the Ice Storage Bin
1. Pull the covering panel up from the bottom.
2. Lift the plastic shutoff arm so it clicks into the Off (up) position.
3. Lift up the front of the storage bin and pull it out.
4. Replace the bin by pushing it in all the way or the dispenser will
not work.
5. To restart ice production, lower the plastic shutoff arm into
the ON (down) position. Make sure the door is closed tightly.

Water Filtration System

Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Water Filter Status Light (on some models)
The filter status light will help you know when to change your
water filter, this is located in the refrigerator control panel.
The light will turn on red. This tells you that it is almost time to
J
change the filter.
It is recommended that you replace the filter when the status light
J
changes to red OR water flow to your water dispenser or ice maker
decreases noticeably.
NOTE: The filter should be replaced at least every 6 months
depending on your water quality and usage.
Resetting the Filter Status
The reset button is located on the control panel in the refrigerator
J
compartment. To reset the status light after changing the filter,
press the button TEMP SETTING within 3 seconds.
The status light will change from red to off when the system is
reset.
Changing the Water Filter
Style 1
A. Water filter cover door
1. Locate the water filter cover door in the base grille, and pull open
the filter door. The filter will be released and then be ejected as the
door is opened.
2. When the door is completely open, pull the filter straight out.
NOTE: There may be some water in the filter. Some spilling may
occur. Use a towel to wipe up any spills.
3. Take the new filter out of its packaging and remove the covers
from the O-rings. Be sure the O-rings are still in place after the
covers are removed.
4. With the arrow pointing to the left (toward the filter cover door's
hinge), align the new filter with the filter housing and slide it into
place. The filter cover door will automatically begin to close as the
new filter is inserted.
5. Close the filter cover door completely in order to snap the filter into
place. You may need to press hard.
6. Flush the water system. See the "Water and Ice Dispensers"
section.
Style 2
1. Locate the water filter cover door in the base grille, and pull open
the filter door.
A. Water filter cover door
2. Twist the water filter and turn 90o counterclockwise to unlock.
3. Pull the filter out of the housing.
5
A
A