Table des Matières
Publicité
Error Messages
Messages d'erreur
Fehlermeldungen
Foutmeldingen
& 116
R
EN
& 117
R
FR
& 118
R
DE
& 119
R
NL
116
EN
Error Messages
Paper jam inside or back side of the product. Press
see how to remove the paper.
Paper out or paper jam. Load paper or remove the
jammed paper and press x.
Paper jam. Open the scanner unit to remove paper. Press
to see how to open it.
Paper jam in the Automatic Document Feeder (ADF).
Remove the jammed paper.
Paper feed error or jam. Remove the paper and reload
paper correctly. See your documentation.
Communication error. Make sure the computer is
connected, then try again.
Printer error. Turn power off and then on again. For details,
see your documentation.
A printer's ink pad is nearing the end of its service life.
Please contact Epson Support.
A printer's ink pad is at the end of its service life. Please
contact Epson Support.
Backup Error.
Error Code xxxxxxxx
No dial tone detected. Try Check Fax Connection.
The combination of IP address and subnet mask is invalid.
See your documentation.
Recovery Mode
to
& 124
R
Load some paper or clear the jammed paper. Otherwise, make sure the
number of sheets does not exceed the limit specified for the type of
media you are using.
& 24
R
& 128
R
& 129
R
& 130
R
Make sure the computer is connected correctly. If the error message
still appears, make sure that scanning software is installed on your
computer and that the software settings are correct.
Turn the printer off and then back on. Make sure that no paper is still in
the printer. If the error message still appears, contact Epson support.
Press x to resume printing. The message will be displayed until the ink
pad is replaced. Contact Epson support to replace ink pads before the
end of their service life. When the ink pads are saturated, the printer
stops and Epson support is required to continue printing.
Contact Epson support to replace ink pads.
A problem occurred and backup was canceled. Make a note of the
error code and contact Epson support.
Make sure the phone cable is connected correctly and the phone line
& 62 If you connected the product to a PBX (Private Branch
works.
R
Exchange) phone line or Terminal Adapter, turn off the Dial Tone
Detection.
& 89
R
Refer the online Network Guide.
The firmware update has failed. You will need to re-attempt the
firmware update. Ready a USB cable and visit your local Epson website
for further instructions.
Solution
Publicité
Table des Matières
