Table des Matières
Publicité
Error Messages
Messages d'erreur
Fehlermeldungen
Foutmeldingen
& 78
R
EN
& 79
R
FR
& 80
R
DE
& 81
R
NL
EN
Error Messages
Paper jam. Open the scanner unit and remove the jammed
paper. Then close the scanner unit and press x. See your
documentation.
Paper jam. Open the scanner unit, remove jammed paper
in the product, then power off and on again. For details,
see your documentation.
Communication error. Make sure the computer is
connected, then try again.
A printer error has occurred. Turn power off and then on
again. For details, see your documentation.
A scanner error has occurred. Turn power off and then on
again. If the error is not fixed, contact your dealer.
The printer's ink pads are nearing the end of their service
life. Please contact Epson Support.
The printer's ink pads are at the end of their service life.
Please contact Epson Support.
Error in the data. The document cannot be printed. The
data is not available because of a malfunction in the
sending device.
Error in the data. The document may not be printed
correctly. A part of the data is corrupted or cannot be
buffered.
Cannot recognize the device.
Cannot recognize the memory card or disk.
Backup Error.
Error Code xxxxxxxx
The combination of IP address and subnet mask is invalid.
See your documentation.
Solution
& 86
R
& 87
R
Make sure the computer is connected correctly. If the error message
still appears, make sure that scanning software is installed on your
computer and that the software settings are correct.
Turn the printer off and then back on. Make sure that no paper is still in
the printer. If the error message still appears, contact Epson support.
Turn the printer off and then back on. If the error message still appears,
contact Epson support.
Contact Epson support to replace ink pads before the end of their
service life. When the ink pads are saturated, the printer stops and
Epson support is required to continue printing.
Contact Epson support to replace ink pads.
See the documentation for the device transmitting the data. (Cause:
The data is not available because of a malfunction in the device.)
See the documentation for the device transmitting the data. (Cause: A
part of the data is corrupted or cannot be buffered.)
Make sure the storage disk has been inserted correctly.
Make sure the memory card or storage disk has been inserted correctly.
If so, check to see if there is a problem with the card or disk and try
again.
A problem occurred and backup was canceled. Make a note of the
error code and contact Epson support.
Refer the online User's Guide - Networking.
Publicité
Table des Matières
