Télécharger Imprimer la page

Environmentally-Friendly Disposal - Valentin SPX II Guide De Référence Rapide

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 74
CAUTION!
Two-pole fuse.
Before opening the housing cover, disconnect the printing system from the mains supply and wait for a
moment until the power supply unit has discharged.
NOTICE!
For Norway and Sweden
Devices which are attached via a power connector with a connection to safety earthing to the safety earthing of the
electric equipment of the building and to a cable distribution system with coaxial cables can cause fire risks under
certain circumstances. Therefore the connection with a cable distribution system must be made by a device which
provides an electric insulation underneath a specific frequency range.

Environmentally-Friendly Disposal

Manufacturers of B2B equipment are obliged to take back and dispose of old equipment that was manufactured after 13 August
2005. As a principle, this old equipment may not be delivered to communal collecting points. It may only be organised, used a nd
disposed of by the manufacturer. Valentin products accordingly labelled can therefore be returned to Carl Valentin GmbH.
This way, you can be sure your old equipment will be disposed of correctly.
Carl Valentin GmbH thereby fulfils all obligations regarding timely disposal of old equipment and facilitates the smooth reselling
of these products. Please understand that we can only take back equipment that is sent free of carriage charges.
The electronics board of the printing system is equipped with a battery. This must only be discarded in battery collection
containers or by public waste management authorities.
Further information on the WEEE directive is available on our website www.carl-valentin.de.
CAUTION!
In consequence of the necessity of being able to
insert the thermal transfer ribbon in a convenient
manner, the requirements of EN 60950-1/
EN 62368-1 regarding the risk of injuries to the
fingers are not complied with at the location
marked with arrows.
These requirements must be insured by
means of installation into the end device.
English
SPX II
111

Publicité

loading