Warn 88225 Instructions D'installation page 4

1. Remove factory bumper.
2. If Warn plow mount is being installed along with bumper,
install u-bolt and fasteners found in plow mount kit. Note:
Plow mount must be installed on vehicle before bumper
installation. See figure 1.
3. Install tube (A2) to bumper (A1) using fasteners (B1, B2,
B3). See figure 2.
4. Install side brackets (A3) to bumper (A1) to bumper using
fasteners (B4, B5). Do not tighten. See figure 3.
©2012 Warn Industries, Inc.WARN® and the WARN logo are trademarks of Warn Industries Inc.
I N S T A L L A T I O N I N S T R U C T I O N S
4 88226A1