Storing Settings To A Program Memory; Loop Recording - Korg KAOSSILATOR PRO Manuel D'utilisation

you're pressing the button, the corresponding
BPM value will appear in the display, and that
BPM value will be set.
TIP: You can't use Tap Tempo if the KAOSSILATOR
PRO is synchronized to MIDI timing clock data that's
received from an external MIDI device.
MIDI Sync function
The BPM of the KAOSSILATOR PRO can be
set to follow MIDI Time Clock messages from
an external MIDI device. Connect the MIDI
OUT connector of an external MIDI device
(such as a sequencer set to transmit MIDI time
clock messages) to the MIDI IN connector of
the KAOSSILATOR PRO.
TIP: This function will not synchronize sequence
data with the KAOSSILATOR PRO's rhythm pattern
programs. If you want to synchronize sequenced
data and the KAOSSILATOR PRO's internal rhythm
patterns, you will either have to insert a Touch Pad
On message into the beginning of each measure of
your sequence data, or touch the touch pad at the
beginning of each of the KAOSSILATOR PRO phras-
es to start the pattern.
TIP: If you want the KAOSSILATOR PRO to receive
Timing Clock and Touch Pad On messages, go to
MIDI Setting (→p.20), and select "Applying the MIDI
message filter" (→p.21) so that these messages will
be received.
Storing settings to a PROGRAM
MEMORY
The PROGRAM MEMORY buttons allow you
to save and instantly recall your eight favorite
KAOSSILATOR PRO programs and settings.
Stored data
- Program
- Scale
- Key
- Note range
Storing
1. Set the KAOSSILATOR PRO to the condi-
tion you want to store.
2. Press the WRITE button.
The PROGRAM MEMORY button and the
WRITE button will blink.
10
3. Press the PROGRAM MEMORY button of
the number that you want to use to store the
settings; the settings will be stored, and then
the KAOSSILATOR PRO will return to the pro-
gram display.
Never turn off the power or perform any other opera-
tions while settings are being stored. Doing so may dam-
age the data.
Recalling
1. Press one of the PROGRAM MEMORY but-
tons (1–8); the settings stored in that memory
location will be recalled.
TIP: You can change the content that is recalled when
you press a PROGRAM MEMORY button (→p.14).

Loop recording

You can create a phrase by overdubbing pro-
gram sounds or audio input. A phrase of up to
four measures can be recorded into each of
the four banks.
TIP: The phrases you recorded will be lost when you
turn off the power. If you want to save your phrases,
write them to an SD card (→p.17) before you turn off
the power, or use the KAOSSILATOR PRO Editor to
save the phrases.
TIP: For several seconds immediately after record-
ing, it won't be possible to resume playback from a
state where all banks are stopped. Please wait until
the LOOP RECORDER BANK button has stopped
blinking before you attempt to play back.
Recording
Recording a mix of the program's sound and
the audio input
1. Press the REC button. When you press the
button, the LOOP RECORDER BANK buttons
and the REC button will blink; the KAOSSILA-
TOR PRO will be in record-ready mode.
2. Press the LOOP RECORDER BANK but-
ton that you want to use for recording; that
LOOP RECORDER BANK button will light-up,
and recording will begin.
3. When you want to stop recording, press
the LOOP RECORDER BANK button; record-
ing will stop, and the KAOSSILATOR PRO will
switch to playback.