Philips Lumea BG9041 Mode D'emploi page 26

Lithium-ion battery
Optical exposure
Maximum optical energy
Optical homogeneity
Repetition time
Pulse duration
Flash interval
Pulse sequence
Troubleshooting
Problem
The device/adapter
becomes warm during use.
When I place the device on
the skin, it does not release
a flash. The 'ready to flash'
light blinks orange.
The ready to flash light
blinks orange and all 5
intensity lights blink as well.
The ready to flash light
does not light up white.
2 x 3.6 Volt 1000 mAh
2.4-6.5 J/cm²
4.8 - 23 J
Max. +/- 30 % deviation from average optical exposure in
treatment area
0.9 s - 2 s (corded), 1.6 s - 3.5 s (cordless)
<2.5 ms
Between 1-3.5 s depending on battery/mains connected use
Single pulse
Possible cause
It is normal for the device and
adapter to become warm (but
not too hot to touch) during
use.
The fan is not working.
The cooling airflow of the fan
is blocked by hands or a
towel.
Your skin tone in the area to
be treated is too dark.
The device needs to be reset. To reset the device take the plug out of
The device is not completely
in contact with your skin.
Solution
Use the device in a slightly cooler
environment and/ or let it cool down
before continuing use.
Check if the attachment is well
connected. Clean the connectors on the
attachment if needed. In case the
attachment is well connected and it is
possible to produce flashes with the
device, contact the Consumer Care
Center in your country, your Philips
dealer or a Philips service center.
Make sure the cooling airflow of the fan
is unblocked.
Treat other body areas with lighter skin
tones with Lumea.
the socket, wait for 30 minutes to let the
device cool down. The device should
function normally again. In case it doesn't
work again, contact the Consumer Care
Center in your country.
Place the device at a 90 degree angle on
the skin so that the integrated safety
system in in contact with your skin.
English
27