Toastess Elegance TDF-20 Mode D'emploi page 14

Booklet TDF-20 6/15/04
SAFETY RELEASE POWER CORD
The Safety Release power cord attaches to the appliance with a magnetic
connector. This magnetic connector will detach from the appliance if the cord
is pulled on accidentally. DO NOT allow the cord to hang over the edge of the
counter. DO NOT use this appliance with an extension cord.
The magnetic end fits into the socket of the fryer in only one direction. The small
black tabs must be placed on the left side of the socket. Always attach the
magnetic end of the cord directly to the fryer socket prior to plugging into a wall
outlet. When disconnecting, always remove the plug from the wall outlet first.
If the magnetic power cord becomes damaged in any way, contact Toastess
International at the address listed at the back of this booklet for a replacement.
DO NOT attempt to permanently attach the power cord to this appliance.
DO NOT use any other power cord on this appliance.
HOW TO USE
1. Place the Fryer on a flat heatproof surface, close to a 120 volt wall outlet.
2. Open the Lid by pressing on the Lid Release.
3. Smear the inner face of the Viewing Window with oil to prevent condensation
from forming and to enable the cooking process to be checked.
4. Pour 1.8 - 2 litres/quarts of oil into fryer. Peanut, soya or other high quality
vegetable oil is recommended. Ensure that the oil level is maintained
between the MIN and MAX markings on the inside of the Fryer.
NOTE: Do not use the Fryer without oil. The Fryer will be damaged and
the warranty will be voided, if heated dry.
5. Close the Cover by gently pressing it down until it clicks.
6. Plug the cord into the wall outlet. Adjust the Temperature Control Knob
to the required temperature and the Indicator Light will come on.
7. Preheat until the Indicator Light goes out. NOTE: The Indicator Light will
turn on and off during the cooking cycle to maintain the preset temperature.
8. Prepare the food to be cooked. Cut food into uniform size pieces so they
will cook evenly. Pat food dry before cooking. NOTE: Adding wet foods to
cooking oil will cause oil to splatter or foam.
9. Raise the Lid by pressing on the Lid Release.
11:34 AM Page 14
4